Intake and Engine Cover
The other day I finally finished the intake. These are the parts that I used:
- Cobra intake elbow
- 3.5″ 60 degree silicone elbow
- 3.5″ aluminum tubing (1/16″ wall thickness, and I believe 9 inches length)
- 3.5″ hump coupler
- 3.5″ grommet
- Aluminum intake box that I made from 0.3″ sheet
- K&N RU-3130 filter from Amazon
I still have to wrap it in some insulation tape to keep the heat out and mount a couple of sensors, but this is pretty much what it looks like.
The cobra intake elbow does not fit under the existing engine cover, so I had to make a small cutout for it and then fabricate a small cover to protect the top from engine heat.