Fitting the engine

Today I finally managed to bolt in the engine for the first time. This was a very frustrating experience, especially trying to do this on my own using a set of stands and a pallet jack. At first I thought I could just roll the whole assembly in together and just bolt it all in inside. I played around with it for a few hours and failed miserably. There’s just too many things to get in the way and too many holes to line up in one shot. 

Today I partially disassembled the engine mounts and tried fitting everything piece by piece. This was still a huge pain in the butt, but at least I managed to put it all together. The clearance seems to be pretty good, and I don’t expect to be doing much more cutting. I am a little more concerned about the air intake situation since there’s only 6.75″ of space between the manifold opening and the firewall.

The engine is in

The way it is now, the engine is slightly tilted towards the front. I may have to add some spacers to the engine or transmission mounts to level it out.